excitation current
英 [ˌɛksɪˈteɪʃən ˈkʌrənt]
美 [ˌɛksaɪˈteɪʃən ˈkɜːrənt]
网络 激励电流; 激发电流; 励磁电流; 激磁电流
双语例句
- On this basis, proposed the theories in the regulation of excitation current by detecting the active component and reactive component of the load.
在此基础上，提出了通过负荷电流的有功分量和无功分量来调节励磁电流的理论。 - This dissertation gives the following experiments methods and results: rotor time constant estimation, the test of excitation current, the effect verifying of vector control algorithm. Some field assembling results are listed too.
重庆大学硕士学位论文论文给出了转子时间常数辨识、励磁电流测定、矢量控制算法验证等实验的方法和结果，也给出了现场装车实验的一些结果。 - This iterative method can not only determine Potier reactance Xp accurately, but use to analyse the excitation current, load angle and armature reaction.
这种迭代方法不仅可以准确地测试保梯电抗，而且对于稳态运行时励磁电流、功角、电枢反应的分析都有重要的作用。 - The phase differences between excitation current and armature current, magentic flux and transformer potential and the amplitudes of all these variales have all been calculated at the two frequencies.
对不同频率时的激磁电流与电枢电流，磁通与变压器电势间的相位差和数值进行了理论计算。 - By calculating the excitation current of CT caused by DC component, its transient saturation behavior is analyzed.
通过对非周期直流分量电流引起的电流互感器暂态饱和励磁电流进行计算，对电流互感器的暂态饱和特性进行了分析。 - The DSP realizes functions of sampling, PI regulation, communication and so on to digitally control the excitation current of arc-suppression coil with magnetic bias.
DSP主要完成采样、PI调节和通信等，实现偏磁式消弧线圈励磁电流的数字控制。 - The design of excitation current controller contains the main circuit, sample circuit, control circuit, speed measurement circuit and so on.
对励磁控制器的主电路、采样电路、控制电路，测速电路等电路进行了设计。 - In this paper, the equivalent circuit of typical permanent magnet actuator is analyzed, and the excitation current wave is optimized under definite redundancy and demanded minimum impulse power.
首先，通过分析典型永磁操动系统等效电路，在一定的冗余下优化励磁电流波形，使所需的脉冲功率最小； - A mixing frequency excitation current source is designed according to the analysis of requirements of the bioelectric impedance measuring system.
通过分析生物阻抗测量系统的需求，设计了一种应用于生物阻抗测量的混频激励电流源。 - The principles and method of selecting transformer fuse were introduced according to the factors such as peak value of transformer excitation current, rated current and secondary fault current of transformer, and the selection method of cable section for engineering was described.
文中较详细地介绍了根据变压器励磁电流峰值、变压器额定电流、二次侧故障电流等因素选择变压器熔断器的原则与方法，以及工程上电缆截面选择方法。